Xerox WorkCentre 5687 Series Service Manual page 308

Y N
Perform the steps that follow:
• Go to the 05E DADH Feed Clutch Failure RAP and check CL05-025.
• ADJ 5.1, DADH Drive Belt Adjustment.
Enter dC330 code 05-010 to energize the DADH feed solenoid, SOL05-010. The
assembly lowers, then raises after 10 seconds.
Y N
Go to Flag 2. Check SOL05-010.
References:
• GP 12 How to Check a Solenoid or Clutch.
• P/J183, DADH PWB and P/J201.
• 01G +24V Distribution RAP.
• The 24V return in the 01B 0V Distribution RAP.
Install new components as necessary:
• DADH feed solenoid, PL 5.15 Item 5.
• DADH feed assembly, PL 5.15 Item 18.
• DADH PWB, PL 5.10 Item 5.
Perform the steps that follow:
• Check that the DADH feed sensor, Q05-330 is installed correctly. If necessary, install a
new feed roll assembly, PL 5.15 Item 1.
• Ensure the feed motor drive belt and CVT motor drive belt are tensioned correctly, ADJ
5.1.
• When large documents are fed (A3 or 11x17 inch), check the items that follow:
– Check that the CVT motor rotates freely, refer to 05D DADH Motor Failure RAP
– Check the CVT drive belt, refer to ADJ 5.1 DADH Drive Belt Adjustment.
– Check that the CVT roll is clean and rotates freely, refer to ADJ 5.4.
NOTE: If necessary install a new CVT motor, PL 5.25 Item 9.
• Go to the 05E DADH Feed Clutch Failure RAP and check CL05-025.
• Make sure that the size of the documents are sensed correctly. Refer to the 05C Docu-
ment Size Sensor Failure RAP.
Status Indicator RAPs
05-330B, 05-331B
feed roll
P/J201
Feed roll motor
August 2007
2-116
CVT motor MOT 05-030
Top cover interlock switch
Feed motor
MOT05-020
DADH feed sensor
Feed roll assembly
Q05-330
Figure 1 Component location
WorkCentre 5687 Family
Feed clutch
CL05-025