Suzuki Baleno Manual page 1471

1. Ignition coil bolt 3. High-tension cord
2. Ignition coil assembly
CYLINDER HEAD COVER
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect breather hose and PCV valve from head cover.
3) Remove ignition coil assemblies with high-tension cord.
4) Remove cylinder head cover with cylinder head cover gasket
1. Cylinder head
cover and O-rings.
2. Cylinder head
cover gasket
3. O-rings
INSTALLATION
1) Install O-rings and cylinder head cover gasket to cylinder head
cover.
NOTE:
Be sure to check each of these parts for deterioration or
any damage before installation and replace if found defec-
1. Cylinder head
tive.
cover
2. Cylinder head
cover gasket
3. O-ring
2) Install cylinder head cover to cylinder head and tighten cover
bolts to specified torque.
Tightening Torque
(a): 11 N
NOTE:
When installing cylinder head cover, use care so that cylin-
der head cover gasket or O-rings will not get out of place
or fall off.
3) Install ignition coil assemblies with high-tension cord.
4) Connect PCV valve and breather hose to head cover.
5) Connect negative cable at battery.
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-11
.
m (1.1 kg-m, 8.0 lb-ft)