Suzuki Baleno Manual page 1461

WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
D Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "Air Bag System Components and Wiring Location View" un-
der "General Description" in air bag system section in order to confirm whether you are perform-
ing service on or near the air bag system components or wiring. Please observe all WARNINGS
and "Service Precautions" under "On-Vehicle Service" in air bag system section before perform-
ing service on or around the air bag system components or wiring. Failure to follow WARNINGS
could result in unintentional activation of the system or could render the system inoperative. Ei-
ther of these two conditions may result in severe injury.
D Technical service work must be started at least 90 seconds after the ignition switch is turned to
the "LOCK" position and the negative cable is disconnected from the battery. Otherwise, the sys-
tem may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
NOTE:
D Whether the following systems (parts) are used in the particular vehicle or not depends on specifica-
tions.
Be sure to bear this in mind when performing service work.
D EGR control system
D EVAP canister, EVAP canister purge valve and vacuum hose
D Heated oxygen sensor
D Three way catalytic converter
GENERAL DESCRIPTION
DIAGNOSIS . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Diagnosis Table . . . . . . . . . . . . . . . . . . . . . . . .
Compression Check . . . . . . . . . . . . . . . . . . . .
Engine Vacuum Check
Oil Pressure Check . . . . . . . . . . . . . . . . . . . .
Valve Lash (Clearance)
ON-VEHICLE SERVICE
Air Cleaner Element . . . . . . . . . . . . . . . . . . . .
Air Cleaner Outlet Hose
Cylinder Head Cover . . . . . . . . . . . . . . . . . . .
Throttle Body and Intake Manifold
Exhaust Manifold . . . . . . . . . . . . . . . . . . . . . .
Timing Belt and Belt Tensioner
Oil Pan and Oil Pump Strainer
SECTION 6A1
ENGINE MECHANICAL
(G13 AND G16 TYPE ENGINE)
CONTENTS
. . . . . . . . . . . . . . . . 6A1- 2
6A1- 5
6A1- 5
6A1- 5
. . . . . . . . . . . . . . . . . . 6A1- 6
6A1- 7
. . . . . . . . . . . . . . . . . 6A1- 8
. . . . . . . . . . . . . . . . . . 6A1-10
6A1-10
. . . . . . . . . . . . . . . . . 6A1-10
6A1-11
. . . . . . . . 6A1-12
6A1-15
. . . . . . . . . . . 6A1-17
. . . . . . . . . . . 6A1-23
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-1
Oil Pump . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rocker Arms, Rocker Arm Shaft and
Camshaft . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Valves and Cylinder Head
Piston, Piston Rings, Connecting Rods and
Cylinders . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNIT REPAIR OVERHAUL
Engine Assembly . . . . . . . . . . . . . . . . . . . . . .
Main Bearings, Crankshaft and
Cylinder Block . . . . . . . . . . . . . . . . . . . . . . . .
SPECIAL TOOLS . . . . . . . . . . . . . . . . . . . . . . . .
REQUIRED SERVICE MATERIALS
RECOMMENDED TORQUE
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . .
6A1-26
6A1-31
. . . . . . . . . . . . . . . 6A1-37
6A1-49
. . . . . . . . . . . . . . . . 6A1-59
6A1-59
6A1-64
6A1-77
. . . . . . . . 6A1-78
6A1-79
6A1