Suzuki Baleno Manual page 1469

7) If valve lash is out of specification, adjust it to specification by
turning adjusting screw after loosening lock nut. After adjust-
ment, tighten lock nut to specified torque while holding adjusting
screw stationary, and then make sure again that valve lash is
within specification.
Valve
clearance
specifica-
tion
(A): 09917-18211
Tightening Torque
(a): 12 N·m (1.2 kg-m, 9.0 lb-ft)
1. Thickness gauge
8) After checking and adjusting valve lashes at valves (1), (2), (5)
and (7), (or (3), (4), (6) and(8)) rotate crankshaft exactly one full
turn (3605) and check the same at valves (3), (4), (6) and (8) (or
(1), (2), (5) and (7)). Adjust them as necessary.
9) After checking and adjusting all valves, reverse removal proce-
dure for installation.
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-9
When cold
(Coolant temperature
is 15 – 255C or
59 – 775F)
0.13 – 0.17 mm
Intake
(0.005 – 0.007 in)
0.23 – 0.27 mm
Exhaust
(0.009 – 0.011 in)
When hot
(Coolant temperature
is 60 – 685C or
140 – 1545F)
0.17 – 0.21 mm
(0.007 – 0.008 in)
0.27 – 0.31 mm
(0.011 – 0.012 in)