Suzuki Baleno Manual page 1481

1. Dowel pin (crankshaft pulley pin)
2. Crankshaft pulley
6) To take up slack of timing belt, turn crankshaft two rotations
clockwise after installing it. After making sure that belt is free
from slack, tighten tensioner stud first and then tensioner bolt
to each specified torque. Then confirm again that two sets of
marks are aligned respectively.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
(b): 25 N·m (2.5 kg-m, 18.0 lb-ft)
7) Install timing belt outside cover.
Before installing, make sure that seal is between water pump
and oil pump case.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
8) Install crankshaft pulley.
Fit pin hole of pulley to dowel pin on crank timing belt pulley,
and tighten pulley bolts to specified torque.
Tightening Torque
(a): 16 N·m (1.6 kg-m, 11.5 lb-ft)
3. Pulley bolt
9) Clamp harness securely.
10) Install water pump pulley and drive belt.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
1. Water
pump
pulley
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-21