Suzuki Baleno Manual page 1484

6A1-24 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
CLEANING
D Clean mating surface of oil pan and cylinder block. Remove oil,
old sealant, and dusts from mating surfaces and oil pan inside.
D Clean oil pump strainer screen.
D CKP sensor, inside of oil pan and oil pump strainer screen.
INSTALLATION
1) Apply sealant to oil pan mating surface continuously as shown
in figure.
"A" Sealant: 99000-31150
Width "a" : 3 mm, 0.15 in.
Height "b" : 2 mm, 0.1 in.
2) Install oil pump strainer and oil pan.
1. Oil pump strainer
2. O-ring
Install O-ring into cylinder block securely as shown in figure.
3. Oil pan
With oil pump strainer inserted into oil pan, install stainer to cyl-
inder block.
Tighten strainer bolt first and then bracket bolt to specified
torque.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
After fitting oil pan to cylinder block, run in securing bolts and
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts to specified torque.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
3) Install gasket and drain plug to oil pan.
Tighten drain plug to specified torque.
Tightening Torque
(a): 35 N·m (3.5 kg-m, 25.5 lb-ft)
4) Check to make sure that CKP sensor and pulley tooth is free from
any metal particles and damage, install CKP sensor to oil pan.
Tightening Torque
10 N·m (1.0 kg-m, 7.5 lb-ft)