Suzuki Baleno Manual page 1508

6A1-48 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
4) Reverse removal procedure for installation.
5) Adjust drive belt tension, referring to Section 6B.
6) Adjust power steering pump belt tension or A/C compressor
belt tension, if equipped.
Refer to Section 0B.
7) Adjust intake and exhaust valve lashes as previously outlined.
8) Adjust accelerator cable play. Refer to Section 6E1.
9) Adjust A/T throttle pressure control cable play. Refer to Sec-
tion 7B (3 A/T).
10) Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
11) Refill cooling system referring to Section 6B.
12) Connect negative cable at battery.
13) Adjust ignition timing referring to Section 6F.
14) Verify that there is no fuel leakage, water leakage and exhaust
gas leakage at each connection.