Suzuki Baleno Manual page 1490

6A1-30 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Timing belt guide
2. Key
3. Crank timing belt pulley
4. Pulley bolt
5. Flat head rod
4) Install rubber seal between oil pump and water pump.
5) Install timing belt guide, key, and crank timing belt pulley. Refer
to figure for proper installation of these parts. Install timing belt
guide in such a way that its concave side faces oil pump.
With crankshaft locked, tighten crank timing belt pulley bolt to
specified torque.
Tightening Torque
(a): 130 N·m (13.0 kg-m, 94.0 lb-ft)
6) Support engine and remove mounting member. (2WD only)
7) Install timing belt, tensioner, oil pump strainer, oil pan and oth-
er parts as previously outlined.
8) Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
9) Adjust water pump drive belt tension, referring to Section 6B.
10) Adjust power steering pump belt tension or A/C compressor
belt tension, if equipped.
Refer to SECTION 0B.
11) Refill engine with engine oil, referring to item "ENGINE OIL
CHANGE" in SECTION 0B.
12) Connect negative cable at battery
13) After completing installation, check oil pressure by running en-
gine.