Suzuki Baleno Manual page 1496

6A1-36 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Camshaft timing belt pulley
10) Install camshaft timing belt pulley to camshaft while fitting pin
on camshaft into slot at "E" mark.
2. Dwell pin
11) Using special tool, tighten pulley bolt to specified torque.
Tightening Torque
(a): 60 N·m (6.0 kg-m, 43.5 lb-ft)
Special Tool
(A): 09917-68221
12) Install belt tensioner, timing belt, outside cover, crankshaft
pulley and water pump belt as previously outlined.
13) After applying sealant to part "A" as shown in figure, install
CMP sensor case (Distributorless ignition coil case) to cylinder
head and tighten its fixing bolts to specified torque.
"A" Sealant: 99000-31110
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
Install ignition coil assembly to CMP sensor case.
1. O-ring
14) Adjust valve clearance as previously outlined.
15) Install cylinder head cover and air cleaner outlet hose.
16) Check to ensure that the following parts are back in place:
D high tension cords
D CMP sensor coupler
D Couplers to ignition coil assembly
D Other removed parts which have not been reinstalled
17) Connect negative cable at battery.
18) Confirm that ignition timing is within specification referring to
Section 6F3.