Suzuki Baleno Manual page 1507

9) Install rocker arms, washers, rocker arm shaft and camshaft
10) Install CMP sensor case, intake manifold and exhaust man-
INSTALLATION
1) Remove oil gasket and oil on mating surfaces and install new
1. Cylinder head gasket
2. Crankshaft pulley side
3. Flywheel side
2) Check to make sure that oil jet (venturi plug) is installed and if
3) Apply engine oil to cylinder head bolts and tighten them gradu-
"1": Camshaft pulley side
"2": Distributor side
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-47
as previously outlined.
ifold.
head gasket as shown in figure, that is, "TOP" mark provided on
gasket comes to crankshaft pulley side, facing up (toward cylin-
der head side).
it is, that it is not clogged.
When installing it, be sure to tighten to specified torque.
Tightening Torque
(a): 3.5 N·m (0.35 kg-m, 2.5 lb-ft)
ally as follows.
a) Tighten all bolts to 35 N·m (3.5 kg-m, 25.0 lb-ft) according to
numerical order in figure.
b) In the same manner as in 1), tighten them to 55 N·m
(5.5 kg-m, 40.0 lb-ft).
c) In the same manner as in 1) again, tighten them to specified
torque.
Tightening Torque
(a): 68 N·m (6.8 kg-m, 49.5 lb-ft)
Special Tool
(A): 09900-00415
(B): 09900-00411