Configuring The Interval To Perform Statistical Analysis On Port Traffic - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Port Basic Configuration
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
Optical
(virtual-cable-test) function.
Combo electrical port supports VCT function only when it is in UP condition (using
undo shutdown command), normal Ethernet electrical port always supports this
function.

1.2.11 Configuring the Interval to Perform Statistical Analysis on Port Traffic

By performing the following configuration, you can set the interval to perform statistical
analysis on the traffic of a port.
When you use the display interface interface-type interface-number command to
display the information of a port, the system performs statistical analysis on the traffic
flow passing through the port during the specified interval and displays the average
rates in the interval. For example, if you set this interval to 100 seconds, the displayed
information is as follows:
Last 100 seconds input:
Last 100 seconds output:
Table 1-14 Set the interval to perform statistical analysis on port traffic
Enter system view
Enter Ethernet port view
Set the interval to perform
statistical analysis on port
traffic
1.2.12 Enabling Giant-Frame Statistics Function
The giant-frame statistics function is used to ensure transmission of network traffic and
to facilitate statistics and analysis of unusual traffic on the network.
Table 1-15 Enable the giant-frame statistics function
Enter system view
port (including
0 packets/sec 0 bytes/sec
Operation
Operation
system-view
Huawei Technologies Proprietary
Combo optical port)
0 packets/sec 0 bytes/sec
Command
system-view
interface interface-type
interface-number
flow-interval interval
Command
1-11
Chapter 1 Port Basic Configuration
does not support
Description
—
—
Optional
By default, this
interval is 300
seconds.
Description
—
VCT