Configuring A Traffic Policy; Applying The Traffic Policy - Huawei Quidway S9300 Configuration Manual

5 QinQ Configuration
You must specify an existing VLAN ID on the S9300 in this command. You do not need to
create the VLANs specified by the original VLAN tags of received packets.
----End

5.5.5 Configuring a Traffic Policy

Context
Do as follows on the S9300 where you need to configure selective QinQ.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic policy policy-name
A traffic policy is created and the policy view is displayed.
Step 3 Run:
classifier classifier-name behavior behavior-name
The traffic classifier is bound to the traffic behavior in the traffic policy.
----End

5.5.6 Applying the Traffic Policy

Context
Do as follows on the S9300 where you need to configure selective QinQ.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
traffic-policy policy-name inbound
The traffic policy is applied in the inbound direction of the interface.
----End
5-10 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)