Configuration Examples; Example For Configuring Multicast Vlan Replication Based On User Vlans - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Procedure
l
----End
Example
# Run the display multicast static-flow [ mvlan vlan-id ] command to view the static flow in
multicast VLAN 10.
<Quidway> display multicast static-flow
-------------------------------------------------------------------
Vlan
-------------------------------------------------------------------
10
-------------------------------------------------------------------
Total Table(s) : 1

3.6 Configuration Examples

This section provides configuration examples of multicast VLAN replication.
3.6.1 Example for Configuring Multicast VLAN Replication Based
on User VLANs
Networking Requirements
As shown in
connected to Eth0/0/1 of SwitchA. Eth0/0/1 of SwitchA belongs to VLAN 10. HostA, HostB,
and HostC are connected to Eth0/0/2, Eth0/0/3, and Eth0/0/4 of SwitchA and belong to VLAN
100, VLAN 200, and VLAN 300 respectively.
To save network bandwidth, you can configure multicast VLAN replication based on user
VLANs on SwitchA. RouterA then only needs to send one copy of multicast data to the multicast
VLAN, and SwitchA distributes multicast data to user VLANs.
Issue 01 (2011-10-26)
Run the display multicast static-flow [ mvlan vlan-id ] command to view the static flow
in a multicast VLAN.
Figure 3-4, RouterA is connected to the multicast source. GE 1/0/0 of RouterA is
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Multicast VLAN Replication Configuration
(Source, Group)
(*, 225.1.1.1)
48