Configuring The Information Center; Establishing The Configuration Task; Enabling The Information Center - Huawei S9300 Configuration Manual

Hide thumbs Also See for S9300:

Table of Contents

2 Information Center Configuration

2.3 Configuring the Information Center

This section describes how to configure the information center.

2.3.3 (Optional) Naming the Information Channel

2.3.4 Definining the Contents of the Information Channel

2.3.5 (Optional) Setting the Timestamp Format of Output Information

2.3.6 Checking the Configuration

2.3.1 Establishing the Configuration Task

Application Environment

To collect debugging, log, or trap information during the running of the S9300, and to output

the information to the terminal for display or to the buffer or host for storage, you need configure

the information center.

Pre-configuration Tasks

None.

Data Preparation

To configure the information center, you need the following data.

No.

2.3.2 Enabling the Information Center

Context

If the system displays a message indicating that the information center is not enabled after you

run the display info-center command, you need to enable the information center.

2-8

Data

(Optional) Numbers and names of information channels

(Optional) Format of the timestamp

(Optional) Severity level

(Optional) Language used in log information and the address of the log host

(Optional) Size of the log buffer and the trap buffer

Huawei Proprietary and Confidential

Quidway S9300 Terabit Routing Switch

Configuration Guide - Device Management

Issue 02 (2009-08-06)

Table of Contents