Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Data Preparation
To configure PIM BFD, you need the following data.
No.
1
7.12.2 Configuring PIM BFD
Enable PIM BFD on the devices that set up a PIM neighbor relationship.
Context
Do as follows on PIM switchs that set up the neighbor relationship:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface must be a VLANIF interface.
Step 3 Run:
pim bfd enable
PIM BFD is enabled.
By default, PIM BFD is disabled.
----End
7.12.3 (Optional) Adjusting BFD Parameters
You can adjust PIM BFD parameters as required. PIM BFD parameters include the minimum
interval for sending and receiving PIM BFD packets and the local detection multiplier.
Context
Do as follows on two PIM switchs that set up the neighbor relationship:
Issue 01 (2011-10-26)
Data
Minimum intervals for sending and receiving BFD detection messages, and local
detection multiple
NOTE
This function is applicable to NBMA interfaces and broadcast interfaces rather than MTunnel interfaces.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PIM-SM (IPv4) Configuration
176