Optional) Configuring The Mac Address Switchover Time; Checking The Configuration - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
stack slot slot-id priority priority
A stack priority is configured for a specified stack device.
By default, the priority value of a device is 100. A great value indicates a high priority.
----End

3.5.6 (Optional) Configuring the MAC Address Switchover Time

Context
The MAC address switchover time can be configured before or after the stack system is created.
If the MAC address switchover time is configured for all the stack switches before the stack
system is created, the MAC address switchover time of the stack system is specified by the MAC
address switchover time of the master switch after the stack system is created, and the MAC
address switchover time of other member switches keeps the same as that of the master switch.
After the stack system is restarted, the MAC address of the stack is changed into the MAC
address of the new master switch. In this case, the MAC address of the stack system keeps
unchanged if the master switch is unchanged. If the stack system is created before the MAC
address switchover time of the system is configured, you can configure the MAC address
switchover time of the system on the master switch only. In this case, the MAC address
switchover time of other member switches keeps the same as that of the master switch. The
MAC address of the stack system keeps unchanged after the stack system is restarted. Do as
follows on the devices where the MAC address switchover time is to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
stack timer mac-address switch-delay delay-time
The MAC address switchover time of the stack system is configured. By default, the delay of
the MAC address switchover is 10 minutes.
----End

3.5.7 Checking the Configuration

Prerequisite
Run the following commands to check the previous configuration.
Procedure
l
Issue 01 (2011-07-15)
NOTE
Before the stack system is created, the default stack ID is 0. You can run the display stack and display
stack peers commands to view the stack ID of a device.
Run the display stack command to check information about the member switches in a
stack.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Stacking
36