Ntp-Service Unicast-Server - Huawei Quidway S8500 Series Command Manual

Command Manual – System Management
Quidway S8500 Series Routing Switches
interface-type: Specifies the interface type and determine an interface together with the
interface-number parameter.
interface-number: Specifies the interface number and determine an interface together
with the interface-type parameter.
priority: Designates a server as the first choice.
Description
Use the ntp-service unicast-peer command to configure NTP peer mode.
Use the undo ntp-service unicast-peer command to cancel NTP peer mode.
By default, version number number defaults to 3, the authentication is disabled, and the
local server is not the first choice.
This command sets the remote server at ip-address as a peer of the local equipment,
which operates in symmetric active mode. ip-address specifies a host address other
than an IP address of broadcast, multicast, or reference clock. By operating in this
mode, a local device can synchronize and be synchronized by a remote server.
Example
# Configure the local equipment to synchronize or synchronized by a peer at
128.108.22.44. Set the NTP version to 3. The IP address of the NTP packets are taken
from that of Vlan-Interface1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ntp-service unicast-peer 131.108.22.33 version 3 source-interface
Vlan-Interface 1

7.1.17 ntp-service unicast-server

Syntax
ntp-service unicast-server ip-address [ version number ] [ authentication-keyid
keyid ] [ source-interface interface-type interface-number ] [ priority ]*
undo ntp-service unicast-server ip-address
View
System view
Parameter
ip-address: Specifies the IP address of a remote server.
version: Defines NTP version number.
number: NTP version number, ranging from 1 to 3.
authentication-keyid: Defines authentication key.
Huawei Technologies Proprietary
7-14
Chapter 7 NTP Configuration Commands