Setting The Unit Of Data Flow That Transmitted To The Radius Server; Configuring The Local Radius Authentication Server - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Security
Quidway S6500 Series Ethernet Switches
case, you have to remove the domain name before sending the username to the
RADIUS server. The following command of switch decides whether the username to be
sent to RADIUS server carries ISP domain name or not.
Perform the following configurations in RADIUS scheme view.
Table 2-29 Setting the username format transmitted to the RADIUS server
Set Username Format Transmitted to
RADIUS Server
Note:
If a RADIUS scheme is configured not to allow usernames including ISP domain names,
the RADIUS scheme shall not be simultaneously used in more than one ISP domain.
Otherwise, the RADIUS server will regard two users in different ISP domains as the
same user by mistake, if they have the same username (excluding their respective
domain names.)
By default, as for the newly created RADIUS scheme, the username sent to RADIUS
servers includes an ISP domain name; as for the "system" RADIUS scheme created by
the system, the username sent to RADIUS servers excludes the ISP domain name.

2.3.11 Setting the Unit of Data Flow that Transmitted to the RADIUS Server

The following command defines the unit of the data flow sent to RADIUS server.
Perform the following configurations in RADIUS scheme view.
Table 2-30 Setting the unit of data flow transmitted to the RADIUS server
Set the unit of data flow
transmitted to RADIUS server
Restore the unit to the default
setting
By default, the default data unit is byte and the default data packet unit is one packet.

2.3.12 Configuring the Local RADIUS Authentication Server

RADIUS service, which adopts authentication/authorization/accounting servers to
manage users, is widely used in Quidway S6500 series switches. Besides, local
Operation
Operation
Huawei Technologies Proprietary
Chapter 2 AAA and RADIUS Protocol
user-name-format
without-domain }
Command
data-flow-format data { byte | giga-byte |
kilo-byte | mega-byte } packet { giga-packet |
kilo-packet | mega-packet | one-packet }
undo data-flow-format
2-22
Configuration
Command
{ with-domain |