Hitachi H8S/2199 Hardware Manual page 491

Bit 2    Slave Address Recognition Flag (AAS): In I
set to 1 if the first frame following a start condition matches bits SVA6 to SVA0 in SAR, or if the
general call address (H'00) is detected.
AAS is cleared by reading AAS after it has been set to 1, then writing 0 in AAS. In addition, AAS
is reset automatically by write access to ICDR in transmit mode, or read access to ICDR in receive
mode.
Bit 2
AAS Description
0 Slave address or general call address not recognized
[Clearing conditions]
1. When ICDR data is written (transmit mode) or read (receive mode)
2. When 0 is written in AAS after reading AAS = 1
3. In master mode
1 Slave address or general call address recognized
[Setting condition]
When the slave address or general call address is detected when FS = 0 in slave
receive mode
Bit 1    General Call Address Recognition Flag (ADZ): In I
this flag is set to 1 if the first frame following a start condition is the general call address (H'00).
ADZ is cleared by reading ADZ after it has been set to 1, then writing 0 in ADZ. In addition,
ADZ is reset automatically by write access to ICDR in transmit mode, or read access to ICDR in
receive mode.
Bit 1
ADZ Description
0 General call address not recognized
[Clearing conditions]
1. When ICDR data is written (transmit mode) or read (receive mode)
2. When 0 is written in ADZ after reading ADZ = 1
3. In master mode
1 General call address recognized
[Setting condition]
If the general call address is detected when FSX = 0 or FS = 0 is selected in the
slave receive mode.
2
C bus format slave receive mode, this flag is
2
C bus format slave receive mode,
Rev. 1.0, 02/00, page 483 of 1141
(Initial value)
(Initial value)