Hitachi H8S/2199 Hardware Manual page 153

Bit 2    Program-Verify 2 (PV2): Selects program-verify mode transition or clearing (target
address range: H'40000 to H'47FFF). Do not set the ESU2, PSU2, EV2, E2, and P2 bits at the
same time.
Bit 2
PV2 Description
0 Program-verify mode cleared
1 Transition to program-verify mode
[Setting condition]
Setting is available when FWE=1 and SWE2=1 are selected
Bit 1    Erase 2 (E2): Selects erase mode transition or clearing (target address range: H'40000 to
H'47FFF, do not set the ESU2, PSU2, EV2, PV2, and P2 bits at the same time.
Bit 1
E2 Description
0 Erase mode cleared
1 Transition to erase mode
[Setting condition]
Setting is available when FWE=1, SWE2=1, and ESU=1 are selected
Bit 0    Program 2 (P2): Selects program mode transition or clearing (target address range:
H'40000 to H'47FFF). Do not set the ESU2, PSU2, EV2, PV2, and E2 bits at the same time.
Bit 0
P2 Description
0 Program mode cleared
1 Transition to program mode
[Setting condition]
Setting is available when FWE=1, SW2=1, and PSU2=1 are selected
Rev. 1.0, 02/00, page 136 of 1141