Hitachi H8S/2199 Hardware Manual page 339

Bit 4    Input Capture Flag D (ICFD): This status flag indicates the fact that the value of the
FRC has been transferred to the ICRD by the input capture signals.
When an input capture signal occurs while the BUFEB of the TCRX is being set to 1, although the
ICFD will be set out, data transference to the ICRD will not be performed.
Therefore, in buffer operation, the ICFD can be used as an external interrupt by setting the ICIDE
bit to 1.
This flag should be cleared by use of the software. Such setting should only be made by use of the
hardware. It is not possible to make this setting using a software.
Bit 4
ICFD Description
0 [Clearing conditions]
When 0 is written into the ICFD after reading the ICFD under the setting of ICFD = 1
1 [Setting conditions]
When the input capture signal has occurred
Bit 3    Output Comparing Flag A (OCFA): This status flag indicates the fact that the FRC and
the OCRA have come to a comparing match.
This flag should be cleared by use of the software. Such setting should only be made by use of the
hardware. It is not possible to make this setting using a software.
Bit 3
OCFA Description
0 [Clearing conditions]
When 0 is written into the OCFA after reading the OCFA under the setting of OCFA =
1
1 [Setting conditions]
When the FRC and the OCRA have come to the comparing match
Rev. 1.0, 02/00, page 326 of 1141
(Initial value)
(Initial value)