Troubleshooting For The Feed Tray; Paper Is Jammed In The Feed Tray. / The Tray Cannot Be Pulled Out Smoothly - Riso ComColor FT Series Troubleshooting Manual

Troubleshooting for the Feed Tray

This section describes precautions for using the feed tray.
Paper is jammed in the feed tray. /
The tray cannot be pulled out
smoothly.
You may need to pull out the feed tray to remove
paper jammed at the far end of the feed tray.
There is a spring on the right side of the feed tray.
When pulling the tray out, hold it in the way shown
below, without touching the spring.
• To hold the tray with proper balance,
place your right hand on the front cover
part of the tray, and place your left hand
on the left near the back, diagonally
across from your right hand. If you hold
the front part with both hands and pull the
tray, the back end may drop due to the
weight of the tray.
How to Load A3 (Ledger) Paper and B4 (Legal) Paper
Install the paper guides in the proper position for the paper size that you are using. To change the
position of the paper guides, pinch both sides of the paper guide, slide it out and then slide it into the
appropriate hole for the desired paper size.
1
Pull the tray until it stops.
ComColor FT Series Troubleshooting Guide
2
49