Preparing To Print; Setting Up The Paper Feed Tray - Riso RISOGRAPH RN2000 User Manual

Preparing to Print

Setting Up the Paper Feed Tray

Open the Paper Feed Tray.
1
Load printing paper and slide the
2
Feed Tray Paper Guides to fit the
paper width.
Push down the Feed Tray Paper Guide Lock
Levers to lock the guides.
Important!
Do not mix printing paper of different sizes.
Set the paper feed pressure.
3
Position the Paper Feed Pressure Adjustment
Lever at either "NORMAL" or "CARD," according
to the paper to be used.
• NORMAL
• CARD
Tips
Selecting the paper feed mode
You can adjust the paper feed range according to paper type as well.
It may improve the paper feed conditions with certain types of paper.
To adjust the paper feed range, open the Custom Initial setting window in
the Main Display and proceed to [Paper Feed Mode].
Then select an appropriate item according to paper type. ☞ p.70, 73
• Standard
• Card Stock
• Light-weight
• Custom
NOTE
For detailed information about the "Custom" paper feed mode,
consult your service representative.
20
Standard paper
Thick paper such as card stock
Standard paper
Thick paper such as card stock
Light-weight paper
Paper for which special adjustment is required in feeding
Free
Lock Lock
Custom Initial Settings
Multi-up Interval None
Enargy Saving Mode
Enargy Save Timer 10 minutes
Auto Idle Period 12 hours
Semi-Auto>Master
Minimum Print Quantity
Paper Size Display Legal
Paper Feed Mode Standard
Close OK
Custom Initial Settings
Paper Feed Mode
Standard
Card Stock
Light-Weight
Custom
Cancel OK
OFF
OFF
1