The Back Of The Original Is Visible; Moire Interference Occurs; The Paper Becomes Dirty. / Printing Is Not Aligned Properly; No Paper Is Fed. / The Back Of A Card Is Damaged. / Multiple Sheets Of Paper Are Fed - Riso ComColor FT Series Troubleshooting Manual

The back of the original is visible.

If you are copying or scanning an original on
thin paper, the image on the back side of the
original or on the next page may be captured in
the image data.
• Adjust [Scanning Level] to a lighter setting.
[Copy] screen / [Scan] screen / [USB] - [Save]
screen [Scanning Level]
[Storage] - [Save] screen
[Change Setting]
• Place a black piece of paper on the back side of
the original and copy or scan the original again.
• When copying or scanning an original with a
base color, such as a newspaper or magazine,
you can use the [Base Color Level] setting to
adjust the base color level.
[Copy] screen / [Scan] screen / [USB] - [Save]
screen [Base Color Level]
[Storage] - [Save] screen
[Change Setting]

Moire interference occurs.

Moire interference (meshed shadow) can easily
occur when copying or scanning images such
as photographs that have been subjected to
screen processing for publication.
Moire interference can be reduced by configuring
the [Moire Elimination] setting.
[Copy] screen / [Scan] screen / [USB] - [Save]
screen [Image Control]
[Storage] - [Save] screen
[Change Setting]
Elimination]
The paper becomes dirty. /
Printing is not aligned properly.
The paper may be too dark for printing and
copying.
When printing on dark colored paper, the machine
may not be able to detect the paper size, resulting
in misaligned printing, image loss, or soiled paper
edges.
The paper size may not be set properly.
For the paper size setting, make sure that the
[Paper Size] and [Paper Type] settings on the
printer driver screen match the corresponding
settings on the machine.
32
select the folder
[Scanning Level]
select the folder
[Base Color Level]
[Moire Elimination]
select the folder
[Image Control] [Moire
Configure the same paper size and type settings
on the machine as those on the printer driver.
[Print] screen select the job
Setting] in the sub menu
[Paper Tray Setting]
Type]
No paper is fed. / The back of a
card is damaged. / Multiple sheets
of paper are fed.
The [Thickness] setting in [Paper Type] may
not match the paper properties (paper
thickness).
Correctly configure the [Thickness] setting in
[Paper Type].
For printing:
[Print] screen select the job
Setting] in the sub menu
[Paper Tray Setting]
[Thickness]
[Storage] - [Load] screen / [USB] - [Load] screen
select the folder
document [Change Setting] in the sub menu
[Paper Selection]
[Paper Type] [Thickness]
For copying:
[Copy] screen [Paper Selection]
Tray Setting] [Paper Type]
[Storage] - [Save] screen
[Change Setting] [Paper Selection]
Tray Setting] [Paper Type]
For more information, see "Paper Selection" in the
"User's Guide".
The paper feed pressure may need to be
adjusted to suit the paper thickness.
Set the paper feed pressure adjustment lever to "
(NORMAL)" or " (CARD)" based on the type
of paper that is loaded.
Normally, set the lever to "
feeding is a problem, set this to "
ComColor FT Series Troubleshooting Guide
[Change
[Paper Selection]
[Paper Size] or [Paper
[Change
[Paper Selection]
[Paper Type]
[Open] select the
[Paper Tray Setting]
[Paper
[Thickness]
select the folder
[Paper
[Thickness]
(NORMAL)". If paper
(CARD)".