Power On The U8903A; Preset The U8903A - Keysight U8903A Quick Start Manual

Power On the U8903A

Connect one end of the power cord to the U8903A rear panel AC power inlet and
the other end to an AC voltage source. The U8903A will automatically adjust to
the correct line voltage in the range of 100 Vac to 240 Vac.

Preset the U8903A

A preset does not erase the flash memory, state memory, or I/O configuration. A
preset will delete all customized settings on the U8903A.
To preset the U8903A, you can perform either one of the following steps.
– Send the *RST, SYSTem:PRESet, SYSTem:RESet[:MODE], or
– Press
Presetting the U8903A will not reset the HP8903B configurations and the Legacy
NOTE
Sweep setting.
26
SYSTem:RESet:CHANnel SCPI commands from the PC via the USB, GPIB, or
LAN interface.
on the System panel.
Keysight U8903A Quick Start Guide