Ip Vlan-Flooding - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.3(0.0)
Usage For the multicast mode of NLB, use ARP to associate the IP address of a server
Information cluster with a multicast MAC address in the switch, by entering the arp ip-
address multicast-mac-address command.
Related
clear arp-cache
Commands
show arp

ip vlan-flooding

Enable unicast data-traffic flooding on VLAN member ports.
Syntax
ip vlan-flooding
To disable, use the no ip vlan-flooding command.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.3(0.0)
Default Disabled
Usage By default this command is disabled. There might be some ARP table entries which
Information are resolved through ARP packets which had Ethernet MAC SA different from MAC
1202
Description
Added support for the association of an IP address with a
multicast MAC address on the Z9500.
Added support for the association of an IP address with a
multicast MAC address on the S4810, S4820T, S6000, and
Z9000.
— clears dynamic ARP entries from the ARP table.
— displays the ARP table.
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Microsoft Network Load Balancing