Dcbx Port-Role - Dell S6000 Reference Manual

Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.

dcbx port-role

Configure the DCBX port role the interface uses to exchange DCB information.
S6000
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream
| manual}
To remove DCBX port role, use the no dcbx port-role {config-source |
auto-downstream | auto-upstream | manual} command.
Parameters
config-source |
auto-
downstream |
auto-upstream
| manual
Defaults Manual
Command INTERFACE PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
472
Enter the DCBX port role, where:
• config-source: configures the port to serve as the
configuration source on the switch.
• auto-upstream: configures the port to receive a peer
configuration. The configuration source is elected from
auto-upstream ports.
• auto-downstream: configures the port to accept the
internally propagated DCB configuration from a
configuration source.
• manual: configures the port to operate only on
administer-configured DCB parameters. The port does
not accept a DCB configuration received form a peer or a
local configuration source.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB)