Dell S6000 Reference Manual page 435

validation for DHCP, Ethernet Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based
Routing (PBR).
S6000
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number [vman-
qos | vman-dual-qos number] ecfmacl number ipv4pbr
number }openflow number | fcoe number} [iscsioptacl number]
[vrfv4acl number]
Parameters
default
l2acl number
ipv4acl number
ipv6acl number
ipv4qos
number
l2qos number
l2pt number
Ipmacacl
number
Content Addressable Memory (CAM)
Use the default CAM profile settings and set the CAM as
follows:
• L2Acl : 6
• IPV4Acl : 4
• IPV6Acl : 0
• IPV4Qos : 2
• L2Qos : 1
• L2PT : 0
• IpMacAcl : 0
• VmanQos : 0
• VmanDualQos : 0
• EcfmAcl : 0
• FcoeAcl : 0
• iscsiOptAcl : 0
• ipv4pbr : 0
• vrfv4Acl :0
• Openflow : 0
• fedgovacl : 0
Enter the keyword l2acl and then the number of l2acl
blocks. The range is from 1 to 8.
Enter the keyword ipv4acl and then the number of FP
blocks for IPv4. The range is from 0 to 8.
Enter the keyword ipv6acl and then the number of FP
blocks for IPv6. The range is from 0 to 4.
Enter the keyword ipv4qos and then the number of FP
blocks for IPv4. The range is from 0 to 8.
Enter the keyword l2qos and then the number of FP blocks
for l2 qos. The range is from 1to 8.
Enter the keyword l2pt and then the number of FP blocks
for l2 protocol tunnelling. The range is from 0 to 1.
Enter the keyword ipmacacl and then the number of FP
blocks for IP and MAC ACL. The range is from 0 to 6.
435