Advertise Dcbx-Tlv - Dell S6000 Reference Manual

advertise dcbx-tlv

On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
S6000
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-
reco | pfc] [ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-
reco | pfc}
Defaults All PFC and ETS TLVs are advertised.
Command PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
You can configure the transmission of more than one TLV type at a time; for
Information
example: advertise dcbx-tlv ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS
configuration TLVs (ets-conf). To disable TLV transmission, use the no form of
the command; for example, no advertise dcbx-tlv pfc ets-reco.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Data Center Bridging (DCB)
Enter the PFC and ETS TLVs advertised, where:
• ets-conf: enables the advertisement of ETS
configuration TLVs.
• ets-reco: enables the advertisement of ETS
recommend TLVs.
• pfc: enables the advertisement of PFC TLVs.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
471