Mbgp Commands; Debug Ip Bgp Dampening - Dell S6000 Reference Manual

holdtime
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0

MBGP Commands

Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (ASs).
Dell Networking OS MBGP is implemented as per IETF RFC 1858.
BGPv4 is supported in the following:
Dell Networking Platform Support
OS Version
7.8.1.0, MBGP for S-Series
IPv4 Multicast Only

debug ip bgp dampening

View information on routes being dampened.
S6000
Syntax
debug ip bgp [vrf test | ipv4 {unicast | multicast} | ipv6
{unicast | multicast} dampening
Border Gateway Protocol
Enter a number for the time interval, in seconds, between
the last keepalive message and declaring the router dead.
The range is from 3 to 65535. The default is 180 seconds.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
431