Dcb-Policy Input - Dell S6000 Reference Manual

Usage
Information
As soon as you apply a DCB policy with PFC enabled on an interface, DCBx starts
exchanging information with PFC-enabled peers. The IEEE802.1Qbb, CEE, and CIN
versions of PFC TLV are supported. DCBx also validates PFC configurations
received in TLVs from peer devices.
By applying a DCB input policy with PFC enabled, you enable PFC operation on
ingress port traffic. To achieve complete lossless handling of traffic, also enable
PFC on all DCB egress ports or configure the dot1p priority-queue assignment of
PFC priorities to lossless queues (refer to pfc no-drop queues).
To remove a DCB input policy, including the PFC configuration it contains, enter
the no dcb-input policy-name command in Interface Configuration mode.
Related

dcb-policy input

Commands
dcb-policy input
Apply the input policy with the PFC configuration to an ingress interface.
S6000
Syntax
dcb-policy input policy-name
To delete the input policy, use the no dcb-policy input command.
Parameters
policy-name
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Data Center Bridging (DCB)
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
— applies the input policy with the PFC configuration.
Enter the input policy name with the PFC configuration to an
ingress interface.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
453