NEC Univerge sv8500 Manual page 1891

MG(SIP)> set drs_qos
Input type: (1=IP Precedence/2=DiffServ/
3=ToS): 2
Input DSCP value.
(0-63 default=40):40
Note: DiffServ - ToS field is allocated as shown below.
0 1 2
DSCP
DSCP=Differentiated Service Code Point(6bits)
MG(SIP)> set drs_qos
Input type: (1=IP Precedence/2=DiffServ/
3=ToS): 3
Input ToS value with HEX format.
(00-FE(default=A0)):a0
Note: The conditions of this command are as follows.
• Pressing the Enter key can skip the item, with an exception of "Input type". Be sure to input a value to "Input
type."
• Normally this command is not required to be changed.
• If you set "1" to the least significant bit, an error message "Please input an even number value." is dis-
played.
(20) dtmf_mode
Setting of DTMF relay system (SIP network)
This command is used to specify the DTMF relay system in SIP network. MG-SIP96 supports Out-Band
(RFC2833) and In-Band (G.711 data transmission as voice data). Negotiation, Out-Band, or In-Band can
be assigned.
[Setting Example]
• When Negotiation is selected:
MG(SIP)> set dtmf_mode
3 4 5 6
VOL.2-1638
When DiffServ (=2) is selected:
Specify the service code point of DiffServ
(default: 40).
7
When ToS (=3) is selected:
Specify the ToS field (default: a0).
MG-SIP96