Show System Stack-Ports - Dell S4810 Reference Manual

Stack-unit SW Version: 7.7.1.0
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit:
Auto Data Sync:
Failover Type:
Auto reboot Stack-unit: Enabled
Auto failover limit:
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count:
Last failover timestamp: None
Last failover Reason:
Last failover type:
-- Last Data Block Sync Record: --
------------------------------------------------
Stack Unit Config: succeeded Jul 11 2012 09:42:35
Runtime Event Log: succeeded Jul 11 2012 09:42:35
Related redundancy disable-auto-reboot
Commands fails.

show system stack-ports

Display information about the stacking ports on all switches in the stack.
S4810
Syntax
show system stack-ports [status | topology]
Parameters
status
topology
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1612
Start-up Config: succeeded Jul 11 2012 09:42:35
Running Config: succeeded Jul 11 2012 09:42:35
ACL Mgr: succeeded Jul 11 2012 09:42:35
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
(OPTIONAL) Enter the keyword status to display the
command output without the Connection field.
(OPTIONAL) Enter the keyword topology to limit the table
to just the Interface and Connection fields.
EXEC
EXEC Privilege
mgmt-id 0
Full
Hot Failover
3 times in 60 minutes
0
None
None
– prevents the system from auto-rebooting if it
Stacking