------------------------------------------------
-- Stack-unit Failover Record --
------------------------------------------------
-- Last Data Block Sync Record: --
------------------------------------------------
Dell#
Related
redundancy disable-auto-reboot
Commands
fails.
show system stack-ports
Display information about the stacking ports on all switches in the MXL 10/40GbE stack.
Syntax
show system stack-ports [status | topology]
Parameters
status
topology
Defaults
none
Command
•
Modes
•
Command
Version 8.3.16.1
History
Usage
The following describes the show interfaces command shown in the following
Information
example.
1258
Primary Stack-unit:
Auto Data Sync:
Failover Type:
Auto reboot Stack-unit:
Auto failover limit:
Failover Count:
Last failover timestamp: None
Last failover Reason:
Last failover type:
Stack Unit Config:
Start-up Config:
Runtime Event Log:
Running Config:
ACL Mgr:
LACP:
STP:
SPAN:
(OPTIONAL) Enter the keyword status to display the
command output without the Connection field.
(OPTIONAL) Enter the keyword topology to limit the table
to just the Interface and Connection fields.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
mgmt-id 0
Full
Hot Failover
Enabled
3 times in 60 minutes
0
None
None
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
— prevents the system from auto-rebooting if it
Stacking