Policy Condition Ip Protocol - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition ip protocol

Configures an IP protocol for a policy condition.
policy condition condition_name ip protocol protocol
policy condition condition_name no ip protocol
Syntax Definitions
condition_name
protocol
Defaults
parameter
protocol
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a protocol from a condition; however, at least one classifi-
cation parameter must be associated with a condition.
•
If a source or destination port is specified (through the policy condition source ip port or policy
condition destination ip port commands), the protocol must be specified.
•
The same condition cannot specify an IP protocol with a service or service group.
Examples
-> policy condition cond4 ip protocol 6
Release History
Release 6.1; command was introduced.
Related Commands
policy condition source ip port
policy condition destination ip
port
qos apply
show policy condition
page 33-88
The name of the condition.
The protocol associated with the flow. The range is 0–255.
default
6
Configures a source IP port number for a policy condition.
Configures a destination IP port number for a policy condition.
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012