Show Ip Traffic - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show ip traffic

Displays IP datagram traffic and errors.
show ip traffic
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
The statistics show the cumulative totals since the last time the switch was powered on or since the last
reset of the switch was executed.
•
Packets received on a port that is a member of the UserPorts group are dropped if they contain a source
IP network address that does not match the IP subnet for the port. This is done to block spoofed IP traf-
fic. If the UserPorts group function is active and spoofed traffic was detected and blocked, the output
display of this command will include statistics regarding the spoofed traffic.
•
Note that the presence of spoofing event statistics in the output display of this command indicates that
an attack was prevented, not that the switch is currently under attack.
•
If statistics for spoofed traffic are not displayed, then a spoofing attempt has not occurred since the last
time this command was issued.
Examples
-> show ip traffic
IP statistics
Datagrams received
Total
IP header error
Destination IP error
Unknown protocol
Local discards
Delivered to users
Reassemble needed
Reassembled
page 29-78
= 621883,
= 0,
= 51752,
= 0,
= 0,
= 567330,
= 0,
= 0,
OmniSwitch 6250 CLI Reference Guide
IP Commands
November 2009