Avaya S8700 Maintenance Manual page 2466

Maintenance-Object Repair Procedures
Table 8-673. Test #138 Loss of Signal Alarm Inquiry Test — Continued
Error Test
Code Result Description / Recommendation
1300 FAIL The CSU module/T1 sync splitter or the E1 Sync Splitter is missing.
The CSU module/T1 sync splitter is missing: The
field on the add ds1 form has been administered as
120A1 CSU module or the 401A T1 sync splitter is not physically connected to
the UDS1 board behind the port carrier.
1. If using the 120A1 CSU module or the 401A T1 sync splitter, plug the CSU
2. Run the test again.
The E1 Sync Splitter is missing: The
ds1 form has been administered as
not physically connected to the UDS1 board behind the port carrier.
1. If using the 402A or 403A E1 synchronization splitter, plug the E1SS into
2. Run the test again.
1301 FAIL The 120A1 CSU module or the 401A T1 sync splitter, or the 402A or 403A E1
synchronization splitter is not expected.
The 120A1 CSU module or the 401A T1 sync splitter is not expected: The
120A1 CSU module/T1 sync splitter is physically connected to the UDS1 board
behind the port carrier, but the
form has not been administered as
1. If the 120A1 CSU module/T1 sync splitter is to be used, use the change
2. Run the test again.
The 402A or 403A E1 synchronization splitter is not expected: The 402A or
403A E1 synchronization splitter is physically connected to the UDS1 board
behind the port carrier, but the
form has not been administered as
1. If the 402A or 403A E1 synchronization splitter is to be used, use the
2. Run the test again.
8-1744 Issue 1 May 2002
module/T1 sync splitter into the UDS1 circuit pack's connector on the I/O
connector panel on back of the carrier. Otherwise, change the
field using the change ds1 form to
CSU Type
the UDS1 circuit pack's connector on the I/O connector panel on back of
the carrier. Otherwise, change the
change ds1 form to n .
ds1 command to change the
integrated . Otherwise, physically remove the 120A1 CSU module/T1
sync splitter from the back of the port carrier.
change ds1 command to change the
Otherwise, physically remove the 402A or 403A E1 synchronization splitter
from the back of the port carrier.
Near-End CSU Type
integrated
other
E1 Sync-Splitter?
y but the 402A or 403A E1 Sync Splitter is
E1 Sync-Splitter?
Near-End CSU Type
integrated .
Near-End CSU Type
E1 Sync-Splitter?
.
y
E1 Sync-Splitter?
Continued on next page
but the
Near-End
.
field on the add
field using the
field on the add ds1
field to
field on the add ds1
field to .
y
555-233-143