Cisco ASR 14000 Series Management Command Reference page 728

vty-pool
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
When creating or modifying vty pools, follow these usage guidelines:
•
•
•
•
•
•
•
If you attempt to remove an active vty from the active vty pool when configuring a vty pool, the configuration
for that vty pool fails.
Task ID Task ID
tty-access
Examples This example shows how to configure a user-defined vty pool (test1) that contains vtys 10 through14 and
references the user-defined line template test2:
RP/0/RP0/CPU0:router(config)# vty-pool test1 10 14 line-template test2
Related Commands Command
line
Cisco ASR 14000 Series Router System Management Command Reference
SMR-726
Before creating or modifying the vty pools, enable the Telnet server using the telnet server
command in global configuration mode. See Cisco IOS XR IP Addresses and Services Configuration
Guide and Cisco IOS XR IP Addresses and Services Command Reference for more information.
The vty range for the default vty pool must start at vty 0 and must contain a minimum of five vtys.
The vty range from 0 through 99 can reference the default vty pool.
The vty range from 5 through 99 can reference a user-defined vty pool.
The vty range from 100 is reserved for the fault manager vty pool.
The vty range for fault manager vty pools must start at vty 100 and must contain a minimum of six
vtys.
A vty can be a member of only one vty pool. A vty pool configuration fails if the vty pool includes
a vty that is already in another pool.
Operations
read, write
Description
Enters line template configuration mode for the specified line template.
Terminal Services Commands on Cisco IOS XR Software
OL-17231-01