Cisco ASR 14000 Series Management Command Reference page 703

Terminal Services Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
send
To send messages to one or all terminal lines, use the send command in EXEC mode.
Syntax Description *
line-number
aux 0
console 0
vty number
Defaults
No default behavior or values
Command Modes EXEC
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
The system prompts for the message, which can be up to 500 characters long. Enter Ctrl-Z to end the
message. Enter Ctrl-C to abort this command.
Task ID Task ID
tty-access
Examples
The following example shows how to send a message to all lines:
RP/0/RP0/CPU0:router# send
Enter message, end with CTRL/Z; abort with CTRL/C:
The system will be shut down in 10 minutes for repairs.^Z
Send message? [confirm]
RP/0/RP0/CPU0:router#
***
***
*** Message from tty to all terminals:
***
The system will be shut down in 10 minutes for repairs.
OL-17231-01
send {* | line-number | aux 0 | console 0 | vty number}
Sends a message to all tty lines.
Line number to which the message is sent. A number from 0 to 101.
Sends a message to the auxiliary line.
Sends a message to the console line.
Sends a message to a virtual terminal line (vty). Range is 0 to 99.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
*
Cisco ASR 14000 Series Router System Management Command Reference
send
SMR-701