Cisco ASR 14000 Series Management Command Reference page 20

mirror pause
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
mirror pause
To temporarily pause disk mirroring on a node, use the mirror pause command in EXEC or
administration EXEC mode.
Syntax Description
location {node-id | all}
Defaults
If no node is specified, disk mirroring is paused on the active RP.
Command Modes EXEC
Administration EXEC
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
The mirror pause command temporarily pauses the mirroring of the primary boot device. This
command is primarily useful during an installation operation to prevent significant performance
degradation on single CPU boards. The mirror pause command does not change the configured state of
mirroring, but rather causes the mirroring to be suspended until the mirror resume command is used.
The mirror pause command has no affect if the mirror configuration command is not enabled.
Task ID Task ID
root-lr
Examples
The following example shows how to pause disk mirroring on the active RP:
RP/0/RP0/CPU0:router# mirror pause
Related Commands Command
mirror
mirror resume
Cisco ASR 14000 Series Router System Management Command Reference
SMR-16
mirror pause [location {node-id | all}]
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Description
Configures disk mirroring on a node.
Resumes disk mirroring on a node after it has been temporarily stopped.
Specifies the RP node in a multishelf system. The all keyword
specifies all RP nodes.
Boot Commands on Cisco IOS XR Software
OL-17231-01