Cisco ASR 14000 Series Management Command Reference page 497

Process and Memory Management Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
You can configure the placement policy to allow certain processes to stay where they are (current) or
move just by indicating so through the various affinity choices. The higher the positive value of an
affinity, the stronger the requirement that the process run at a location, and so on. A low or zero point
value would indicate a weaker requirement (or no preference) that a process run at a location.
The affinity location type with the paired option configures the affinity towards the nodes that are paired
(active and standby nodes), and as mentioned earlier, this is the default policy. The affinity location type
using the primary option configures the affinity towards the designated secure domain router system
controller (DSDRSC) node.
Change the current affinity with assistance from Cisco support personnel.
Note
Task ID Task ID
sysmgr
Examples This example shows how to place Border Gateway Protocol (BGP) in a specific location by setting it
with a high attract value. The result is that BGP does not move location under any circumstances other
than a node pair removal.
RP/0/RP0/CPU0:router(config)# placement program bgp
RP/0/RP0/CPU0:router(config-place)# affinity location-type current attract 5000
Related Commands Command
placement program
OL-17231-01
Operations
read, write
Description
Enters placement program configuration mode to set process affinities
(preferences).
Cisco ASR 14000 Series Router System Management Command Reference
affinity location-type
SMR-495