Cisco ASR 14000 Series Management Command Reference page 567

Process and Memory Management Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
show placement program
To display the operational state for each placement program, use the show placement program
command in EXEC mode.
Syntax Description
program
all
Defaults No default behavior or values
Command Modes EXEC
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
The show placement program command displays information that identifies that the process (or
program) is running, where the process is located, locations where the process was rejected, and location
where the process is waiting to start.
Task ID Task ID
sysmgr
Examples
The following example shows that all placement programs are running on the node pair 0/RP0/CPU0 and
0/RP1/CPU0:
RP/0/RP0/CPU0:router# show placement program all
If a program is shown as having 'rejected locations' (i.e., locations on which
it cannot be placed), the locations in question can been seen using the "show
placement policy program" command.
If a program has been placed but not yet started, the amount of time elapsed
since the program was placed is shown in the 'waiting to start' field.
Parentheses around the node indicate that the node has not yet fully booted.
This will be true of standby nodes.
Program
OL-17231-01
show placement program {program | all}
Specific program or program group.
Displays operational state for all placement programs.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read
Placed at location
Cisco ASR 14000 Series Router System Management Command Reference
show placement program
# rejected Waiting
locations to start
SMR-565