Cisco ASR 14000 Series Management Command Reference page 363

Software Package Management Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
install deactivate
To remove a package from the active software set, use the install deactivate command in EXEC or
administration EXEC mode.
Administration EXEC Mode
EXEC Mode
Syntax Description
device:package
auto-abort-timer time
sdr OWNER
location node-id
asynchronous
synchronous
parallel-reload
prompt-level {default |
none}
test
OL-17231-01
install deactivate device:package [auto-abort-timer minutes] [sdr OWNER] [location node-id]
[asynchronous | synchronous] [parallel-reload] [prompt-level {default | none}] [test]
install deactivate device:package [auto-abort-timer minutes] [location node-id] [asynchronous |
synchronous] [parallel-reload] [prompt-level {default | none}] [test]
Device and package, expressed in concatenated form (for example,
disk0:asr14k-mgbl-3.7.1). For the device argument, the value is a
specified storage device, typically disk0:.
Press ? after a partial package name to display all possible matches
available for activation. If there is only one match, press [TAB] to fill in
the rest of the package name.
(Optional) Specifies an abort timer value, time, in minutes, which when
expired loads the last commited loadpath.
(Optional. Administration EXEC mode only) Deactivates a package for
a specific secure domain router (SDR).The only SDR available is
OWNER, which refers to the entire Cisco ASR 14000 Series Router
router.
(Optional) Deactivates a package from the designated node. The node-id
argument is entered in rack/slot/module notation.
Note
(Optional) Performs the command in asynchronous mode. In
asynchronous mode, this command runs in the background, and the
EXEC prompt is returned as soon as possible. This is the default mode.
(Optional) Performs the command in synchronous mode. This mode
allows the installation process to finish before the prompt is returned.
(Optional) Forces all cards on the router to reload at the same time and
then come up with the new software, rather than proceeding according
to the option encoded in the install package.
(Optional) Specifies when you are prompted for input during the
procedure.
(Optional) Verifies the effects of proposed operations without making
changes to the Cisco IOS XR software.
In most cases, a package cannot be deactivated from a node,
because some version of that package must be running on all
supported nodes after the deactivation operation finishes.
default—you are prompted only when input is required by the
•
operation.
none—you are never prompted.
•
Cisco ASR 14000 Series Router System Management Command Reference
install deactivate
SMR-361