Cisco ASR 14000 Series Management Command Reference page 264

hw-module port
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
hw-module port
To enable a SONET/SDH port to be used for Spatial Reuse Protocol (SRP), use the hw-module port
command in global configuration mode. To disable SRP and enable the port for
Packet-over-SONET/SDH (POS), use the no form of this command.
Syntax Description
port-id
srp
location
preconfigure
node-id
Defaults
SRP is disabled on all SONET/SDH ports.
Command Modes
Global configuration
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the
information.
Task ID Task ID
root-lr
Examples The following example shows how to enable a SONET/SDH port to be used for SRP:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# hw-module port 1 srp location 0/1/CPU0
Cisco ASR 14000 Series Router System Management Command Reference
SMR-262
hw-module port port-id srp location [preconfigure] node-id
no hw-module port port-id srp location [preconfigure] node-id
Number that identifies the physical port on a line card.
Sets the port in Spatial Reuse Protocol (SRP) mode
Indicates a specific node location.
(Optional) Specifies the preconfigure option.
Note
Identifies the location of the node on which you want to enable an SRP port,
in the rack/slot/module notation.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
show platform command to view a summary of the nodes in the router, including status
Operations
read, write
Hardware Redundancy and Node Administration Commands on Cisco IOS XR Software
Use the preconfigure option only if a node has not yet been inserted
into the specified location.
OL-17231-01