Cisco ASR 14000 Series Management Command Reference page 344

install activate
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
location node-id
admin-profile
if-active
asynchronous
synchronous
parallel-reload
prompt-level {default |
none}
test
Defaults
Administration EXEC Mode
•
•
EXEC Mode
•
•
Cisco ASR 14000 Series Router System Management Command Reference
SMR-342
(Optional) Activates a package on the designated node. The node-id
argument is expressed in rack/slot/module notation.
Note
Note
(Optional. Administration EXEC mode only.) Activates the package only
for the admin-plane nodes. Admin plane nodes provide system-wide
functionality and do not belong to a specific SDR. Examples of
admin-plane nodes are fabric cards and service processor modules (SPs).
The admin-profile keyword is used to update admin-plane resources
without impacting the routing nodes in any SDRs.
(Optional. Administration EXEC mode only) Activates an optional
package or SMU for an optional package only if a previous version of the
package is already active. Use the if-active keywords when SDRs have
different sets of active software packages.
(Optional) Performs the command in asynchronous mode. In
asynchronous mode, the command runs in the background, and the EXEC
prompt is returned as soon as possible. This is the default mode.
(Optional) Performs the command in synchronous mode. This mode
allows the installation process to finish before the prompt is returned.
(Optional) Forces all cards on the router to reload at the same time and
then come up with the new software, rather than proceeding according to
the option encoded in the install package.
(Optional) Specifies when you are prompted for input during the
procedure.
(Optional) Verifies the effects of proposed operations without making
changes to the Cisco IOS XR software.
The package is activated for all supported nodes on all SDRs in the system.
The operation is performed in asynchronous mode: The install activate command runs in the
background, and the EXEC prompt is returned as soon as possible.
The package is activated on all supported nodes for the SDR.
The operation is performed in asynchronous mode: The install activate command runs in the
background, and the EXEC prompt is returned as soon as possible.
Software Package Management Commands on Cisco IOS XR Software
A package cannot be activated on a single node unless some
version of the package being activated is already active on all
nodes. For example, a Multiprotocol Label Switching (MPLS)
package cannot be active on only one node. If a version of the
MPLS package is already active on all nodes, an MPLS package
then could be upgraded or downgraded on a single node.
To activate a package on all supported nodes, do not specify a
location.
default—You are prompted only when input is required by the
•
operation.
none—You are never prompted.
•
OL-17231-01