Cisco ASR 14000 Series Management Command Reference page 24

reload
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
Examples
The following example shows how to reload the active RP. If a standby RP is in the ready state, then the
router fails over to the standby RP. If the standby RP is not installed or is not in the ready state, then the
router enters ROMMON mode and routing operations stop.
RP/0/RP0/CPU0:router# reload
Updating Commit Database.
Proceed with reload? [confirm] y
PCI0 device[7]: Vendor ID 0x10ee
PCI0 device[7]: Device ID 0x300e
PCI1 device[7]: Device ID 0x1100
PCI1 device[7]: Vendor ID 0x1013
PCI1 device[8]: Device ID 0x649
PCI1 device[8]: Vendor ID 0x1095
PCI1 device[9]: Device ID 0x5618
PCI1 device[9]: Vendor ID 0x14e4
PCI1 device[10]: Device ID 0x5618
PCI1 device[10]: Vendor ID 0x14e4
System Bootstrap, Version 1.15(20040120:002852) ,
Copyright (c) 1994-2004 by cisco Systems, Inc.
Board type is 0x100000 (1048576)
Enabling watchdog
Broadcom 5618 #0 Found on PCI
Broadcom 5618 #1 Found on PCI
No. of BCM 56xx switches found 2 .
BCM Switch #0 initialisation complete.
BCM Switch #1 initialisation complete
G4(7450-SMP-GT64260_A) platform with 2048 Mb of main memory
rommon B1 >
Related Commands Command
config-register
reload (administration
EXEC)
show redundancy
Cisco ASR 14000 Series Router System Management Command Reference
SMR-20
Please wait...[OK]
Description
Defines the configuration register setting in administration EXEC mode.
Performs a reload of a single node or all nodes in the system.
Displays the redundancy status of the RPs.
Boot Commands on Cisco IOS XR Software
OL-17231-01