Cisco ASR 14000 Series Management Command Reference page 656

snmp-server trap-source
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
snmp-server trap-source
To specify the interface (and hence the corresponding IP address) from which a Simple Network
Management Protocol (SNMP) trap should originate, use the snmp-server trap-source command in
global configuration mode. To remove the source designation, use the no form of this command.
Syntax Description
interface-type
interface-id
Defaults
No interface is specified.
Command Modes
Global configuration
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Cisco ASR 14000 Series Router System Management Command Reference
SMR-654
snmp-server trap-source interface-type interface-id
no snmp-server trap-source
Interface type. For more information, use the question mark (?) online help
function.
Either a physical or virtual interface identifier as follows:
Physical interface identifier. Naming notation is rack/slot/module/port
•
and a slash between values is required as part of the notation.
–
–
–
–
In references to a Management Ethernet interface located on a route
Note
processor card, the physical slot number is alphanumeric (RP0 or
RP1) and the module is CPU0.
Example: interface MgmtEth0/RP1/CPU0/0.
Virtual interface identifier. Number range varies depending on interface
•
type.
Note For more information about the syntax for the router, use the question
mark (?) online help function.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
rack: Chassis number of the rack.
slot: Physical slot number of the modular services card or line card.
module: Module number. A physical layer interface module (PLIM)
is always 0.
port: Physical port number of the interface.
SNMP Server Commands on Cisco IOS XR Software
OL-17231-01