Cisco ASR 14000 Series Management Command Reference page 496

affinity location-type
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
affinity location-type
To set the affinity of a placeable program (process) to or from a location type, use the affinity
location-set command in placement program configuration mode. To remove the affinity of a location
set, use the no form of this command.
Syntax Description current
paired
primary
attract
repulse
strength
default
none
Defaults By default, all processes have the following settings:
•
•
•
Specifying an affinity value of default is equivalent to specifying the attract strength argument to be
200.
Command Modes
Placement program configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
The affinity location-type command is used to place a process at a particular location. The default
policy is that the location type be a node pair (active and standby nodes), and that the process does not
move automatically (current = 100) unless a solo node fails and the process must be started on a
different node.
Cisco ASR 14000 Series Router System Management Command Reference
SMR-494
affinity location-type {current | paired | primary} {attract strength | repulse strength | default |
none}
no affinity location-type {current | paired | primary} {attract strength | repulse strength |
default | none}'
location-type current attract strength argument: 100
location-type paired attract strength argument: 60
location-type primary attract strength argument: 40
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Process and Memory Management Commands on Cisco IOS XR Software
Affinity for the current location.
Affinity for a node (or route processor) with a standby node.
Affinity for the primary node.
Specifies a positive affinity.
Specifies a negative affinity.
A positive or negative strength. The range is from 1 to 100000 points.
Sets the affinity location-type default values.
Sets the affinity value to zero points.
OL-17231-01