Cisco ASR 14000 Series Management Command Reference page 696

flowcontrol hardware
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
flowcontrol hardware
To configure the hardware flow control setting for physical terminal connections, use the flowcontrol
hardware command in line console configuration mode. To remove the attribute from the configuration
file and restore the system to its default condition, use the no form of this command.
Syntax Description
in
out
none
Defaults
No default behavior or values
Command Modes
Line console configuration
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the flowcontrol hardware command to set the flow control attribute for physical line connections.
Physical line connections use either the console or auxiliary line template.
Task ID Task ID
tty-access
Examples The following example shows how to restrict the hardware flow control to inbound for the console line
template:
RP/0/RP0/CPU0:router(config)# line console
RP/0/RP0/CPU0:router(config-line)# flowcontrol hardware in
Related Commands Command
show users
Cisco ASR 14000 Series Router System Management Command Reference
SMR-694
flowcontrol hardware {in | out | none}
no flowcontrol hardware {in | out | none}
Specifies inbound flow control.
Specifies outbound flow control.
Specifies no flow control.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Description
Displays information about the active lines on the networking device.
Terminal Services Commands on Cisco IOS XR Software
OL-17231-01