Cisco ASR 14000 Series Management Command Reference page 611

SNMP Server Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
udp-port port
notification-type
Defaults This command is disabled by default. No notifications are sent.
The default UDP port is 161.
When this command is entered without keywords, the default is to send all trap types to the host.
If no version keyword is entered, the default is version 1.
If version 3 is specified, but the security level is not specified, the default security level is noauth.
Command Modes
Global configuration
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
SNMP notifications can be sent as traps. Traps are unreliable because the receiver does not send
acknowledgments when it receives traps. The sender cannot determine if the traps were received. Traps
are discarded as soon as they are sent. Traps are also sent only once.
When the snmp-server host command is not entered, no notifications are sent. To configure the device
to send SNMP notifications, configure at least one snmp-server host command. When the command is
entered without keywords, all trap types are enabled for the host.
OL-17231-01
(Optional) Specifies the User Datagram Protocol (UDP) port of the host to use.
Range is from 1 to 65535. The default UDP port is 161.
(Optional) Type of notification to be sent to the host. If no type is specified, all
available notifications are sent. The notification type can be one or more of the
following keywords:
bgp—Enables SNMP Border Gateway Protocol Version 4 (BGPv4) traps.
•
config—Controls configuration notifications, as defined in the
•
CISCO-CONFIG-MAN-MIB (enterprise 1.3.6.1.4.1.9.9.43.2). The
notification type is: (1) ciscoConfigManEvent.
copy-complete—Enables CISCO-CONFIG-COPY-MIB
•
ccCopyCompletion traps.
entity—Controls Entity MIB modification notifications. This notification
•
type is defined in the ENTITY-MIB (enterprise 1.3.6.1.2.1.47.2) as:
(1) entConfigChange.
fabric—Enables SNMP fabric traps.
•
• fru-ctrl—Enables SNMP entity field-replaceable unit (FRU) control traps.
mpls—Enables SNMP Multiprotocol Label Switching (MPLS) traps.
•
sensor—Enables SNMP entity sensor traps.
•
snmp—Enables SNMP traps.
•
syslog—Controls error message notifications (Cisco-syslog-MIB). Specify
•
the level of messages to be sent with the logging history command.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Cisco ASR 14000 Series Router System Management Command Reference
snmp-server host
SMR-609